Print Back
Polyethylene C-Clamp® and Sealing Rods can be cut to any length. To make an airtight, leak-proof seal, place the C-Clamp®, open side up, on a clean, hard surface. Wrap the open bag end once over the round plastic sealing rod and push the rod down into the "C" shaped opening of the C-Clamp®, inserting the middle of the rod first, then moving outward toward each end. We recommend ordering C-Clamp® Sealing Kits at least 1" longer than the length of the bag end to be sealed. The Rod in each unit (kit) is longer than the C-Clamp®, for easy removal.

C-Clamp® Kits can be ordered in standard lengths to be cut by the end user to needed lengths or you can order to size by selecting the part numbers ending in "X1".
Unit of Measure

Note

N/A Now available in 3 width sizes.

Additional Information

N/A

  • Rod Diameter: 3/8"
  • For Bag Length: 1" to 39"
  • To order "C" Clamp sealing kits in multiples of 1", add "X" and the number of inches to the end of the Catalog No.
  • For example: 27" long "C" Clamp, 3/8" rod diameter = Catalog No. CPSBAGS-138X27.

Specifications

C®-Clamp Length

N/A 1 to 47 in

Nominal Rod Diameter

N/A 1/8 in

Rod Length

N/A 2 to 48 in

Minimum Order Quantity

N/A 1

Suggestion

N/A

  • Before use, thoroughly flush bags with ultra-pure nitrogen or zero air
  • During sampling, Fluoropolymer tubing and Fluoropolymer faced septums must be used in order to prevent sample loss.
  • Bags should not be filled to more than 80% of their maximum volume.
  • Charcoal (Black) Tedlar® bags should be used when sampling light sensitive compounds
  • Do not store compounds in bags long term due to the possibility that chemicals may adsorb onto the bag surface.
  • Bags should not be used to collect reactive or unstable compounds.
  • When shipping bags, do not air-ship unless the bags are stored in a pressurized area.