N/A Valve and Fitting is Stainless Steel.
Locking Combo^® is a registered trademark of Jensen Inert Products, Inc.
Swagelok^® is a register trademark of Swagelok, Inc.
Jaco^® is a registered trademark of Jaco Manufacturing, Inc.
HR^® is a registered trademark of Halkey Roberts, Inc.
Tedlar^® is a registered trademark of E.I. Dupont

N/A Catalog No. SEP-9010-TCLP-10, Replacement Septa for Stainless Steel Fitting, 10 per pack

N/A

• Stainless Steel construction provides durability and ability to withstand use in austere sampling conditions.
• Stainless Steel valve body and nut
• 3/16" OD Stainless Steel stem
• Thumbscrew to lock valve in open or closed position
• Replaceable fluoropolymer faced septum, allows repeated punctures with common lab syringes.
• Septum fitting allows reuse of valve by only replacing septum

N/A FEP is one of the most chemically inert materials for making gas sampling bags. It works well in extreme temperatures ranging from -400 to 400 ºF; allowing it to be used in most stack sampling conditions. 5 mil FEP film is completely resistant to the most severe corrosives. Much more permeable than Multi-Layer or Tedlar®. FEP bags can be specified for applications involving corrosive gases.

N/A

• Before use, thoroughly flush bags with ultra-pure nitrogen or zero air
• During sampling, Fluoropolymer tubing and Fluoropolymer faced septums must be used in order to prevent sample loss.
• Bags should not be filled to more than 80% of their maximum volume.
• Charcoal (Black) Tedlar^® bags should be used when sampling light sensitive compounds
• Do not store compounds in bags long term due to the possibility that chemicals may adsorb onto the bag surface.
• Bags should not be used to collect reactive or unstable compounds.
• When shipping bags, do not air-ship unless the bags are stored in a pressurized area.

N/A

• One of the most chemically inert materials available for making gas sampling bags
• Maximum operating temperature: 400 ºF
• Virtually transparent

N/A

• Works well in extreme temperatures ranging from -400 to 400 ºF; allowing it to be used in all stack sampling conditions
• Heavier gauge (0.005) film is resistant to most severe corrosives as well as tolerates applications involving rough handling or difficult service conditions
• Less expensive than PFA

N/A

• Poor long term storage stability for most VOC's and sulfur compounds
• Much more permeable than Tedlar^®, ALTEF, and Multi-Layer Foil bags
• More expensive than Tedlar^®, ALTEF, Multi-Layer Foil, and TFM bags
• Lower tensile strength than Tedlar^®

N/A

• Stainless Steel construction provides durability and ability to withstand use in austere sampling conditions.
• Thumbscrew to lock valve in open or closed position
• Replaceable fluoropolymer faced septum, allows repeated punctures with common lab syringes.